![]() |
itibiti's led taillight's installed by matt boesch from genius smart parts |
![]() |
||
vanity plates | itibiti pictures | itibiti home | itibiti videos | karen & billo |
painted lights | what's new? | itibiti bling | the wienermobile |
|
||||
i wanted to experiment with exterior led lights on ITIBITI, so i thought i'd
begin with the taillights. after
matt poked around
superbrightleds for a while, he decided
these would be our best bet. led's use so little power, they cause
the turn signals to blink rapidly...thinking the bulbs are burnt out, or
missing. you usually have to install load resistors, which are wired parallel with the turn signal bulbs to simulate the load of a standard filament bulb so the led's blink normally. i'm sure glad matt knew what he was doing because at that point...i was lost! watch the taillight video here! |
||||
|
||||
< back to led's | click pix to view | cabin led's > | ||
|
|
|
||
factory running lights |
factory brake lights |
factory brake/reverse |
||
|
||||
![]() |
||||
ba15
30-led, 12vdc replacement bulb 15mm 1156 single or 1157 dual intensity bayonet base w/wide viewing angle |
||||
|
||||
|
|
|
|
|
load resistors & red/white leds |
check evilution for panel removal |
and so... | it... | ...begins! |
|
|
|
|
|
led is going in that hole! |
one for brake, one for reverse |
drill out hole... | so led's... | ...will fit |
|
|
|
|
|
how do these resistors work? |
shorten resistor screws to fit |
where to mount resistor? |
how 'bout here! clean, huh? |
rear end has to be removed |
|
|
|
|
|
naked drivers side |
naked passenger side |
naked rear end |
first time we plugged in |
"hanging" in there! |
|
||||
![]() |
![]() |
![]() |
||
led running lights |
led running/reverse |
led brake/reverse |
||
|
||||
led taillight video coming soon! | ||||
|
||||
< back to led's | cabin led's > | |||
|
||||
itibiti home | ||||
itibitismart® is not affiliated with smart USA or any authorized smart USA dealership | ||||
need itibiti information?
or
shout out to billo follow me on twitter! |